BATTERY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery removal/installation are shown below.

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
When replacing the battery, use a new battery of the same dimensions with a capacity of 51 Ah or more at a 20-hour rate.
After replacing the battery, install the ventilation hole plug supplied with the new battery or the ventilation hole plug from the old battery to the ventilation hole on the side to which the battery hose is not connected.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	LKA /LDA system	Click here
		Pre-collision system	Click here
		Parking assist monitor system	Click here
	Steering sensor zero point calibration	Variable gear ratio steering system	Click here

PROCEDURE

REMOVE NO. 2 DECK BOARD

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
1. Loosen the nut, and disconnect the cable from the negative (-) battery terminal.
  
  Note
  
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
  
  Click here
REMOVE BATTERY
1. Disengage the claw and disconnect the battery terminal cap.
2. Loosen the nut and disconnect the cable from the positive (+) battery terminal.
3. Remove the 2 nuts and battery clamp sub-assembly.
4. Disconnect the battery exhaust hose from the battery.
5. Remove the battery.