DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL FAN AND GENERATOR V BELT

    Tech Tips

    When re-using the fan and generator V belt, check the entire circumference of the belt for wear and cracks on the ribs and rear side. Replace belts where wear and cracks have advanced to the wire core and belts with missing rib rubber.


    1. B000ULPC01
      *1 Engine Water Pump Assembly
      *2 Scavenging Pump Assembly
      *3 No. 2 Idler Pulley Sub-assembly
      *4 Compressor with Pulley Assembly
      *5 Crankshaft Pulley
      *6 V-ribbed Belt Tensioner Assembly
      *7 Generator Assembly

      Install the fan and generator V belt as shown in the illustration.

      Note

      Hook the back surface side of the fan and generator V belt onto the drive belt tensioner assembly and scavenging pump assembly.

    2. Rotate the V-ribbed belt tensioner assembly counterclockwise, and then remove the 5 mm bi-hexagon wrench.

    3. B000WTDC21
      *a Correct
      *b Incorrect

      Check that the fan and generator V belt is properly set to each pulley.

    4. Start the engine and check that the fan and generator V belt turns smoothly and no abnormal noise occurs.

  2. INSTALL INTAKE AIR CONNECTOR PIPE

    Click here

  3. INSTALL AIR CLEANER HOSE ASSEMBLY

    Click here

  4. CONNECT NO. 3 PCV HOSE

    Click here

  5. CONNECT NO. 2 PCV HOSE

    Click here

  6. INSTALL LOWER RADIATOR AIR DEFLECTOR

    Click here

  7. INSTALL RADIATOR SUPPORT TO FRAME SEAL RH

    Click here

  8. INSTALL RADIATOR SUPPORT TO FRAME SEAL LH

    Click here

  9. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here