REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

   
   

   1. 

      	Install in this Direction (1)
      	Install in this Direction (2)

      Engage the guide and 5 claws to install a new rear door belt moulding assembly as shown in the illustration.

2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

3. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

4. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

   Click here

5. CONNECT REAR DOOR WEATHERSTRIP

   Click here

6. INSTALL REAR DOOR GLASS RUN

   Click here

7. INSTALL REAR DOOR PANEL PROTECTOR

   Click here

8. INSTALL REAR DOOR NO. 1 VENT SEAL

   Click here

9. INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

10. INSTALL REAR DOOR NO. 2 SERVICE HOLE COVER

    Click here

11. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

12. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

13. INSTALL REAR ARMREST ASSEMBLY

    Click here

14. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

    Click here

15. INSTALL REAR DOOR ARMREST COVER SUB-ASSEMBLY

    Click here

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    for 2AR-FE:

    Click here

    for A25A-FKS:

    Click here

    for 2GR-FKS:

    Click here

17. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

18. INSPECT POWER WINDOW OPERATION

    Click here