FRONT BUMPER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here

PROCEDURE


  1. INSTALL FRONT BUMPER ASSEMBLY


    1. w/ Headlight Cleaner System:


      1. Connect the headlight cleaner hose.

    2. w/ Fog Light:


      1. Connect the connector.

    3. B004HH3C01
      B006ZFL Install in this Direction

      Move the front bumper assembly into position and engage the 2 guides and 2 claws as shown in the illustration.

    4. Install the 4 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

    5. Install the 2 clips.

    6. w/ TOYOTA Parking Assist-sensor System:


      1. Connect the connector.

    7. w/ Pre-collision System:


      1. Connect the connector.

    8. B004J0VC01
      B006ZFL Install in this Direction

      Engage the 3 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    9. Install the 8 screws.

    10. Install the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    11. B004LAWC01
      B006ZFL Install in this Direction

      Engage the 4 claws to install the 2 pin hold clips as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    12. Install the front bumper assembly.

  2. INSTALL COOL AIR INTAKE DUCT SEAL


    1. B004N6WC01
      B006ZFL Install in this Direction (1)
      B006WSJ Install in this Direction (2)

      Engage the guide as shown in the illustration.

    2. Install the cool air intake duct seal with the 5 clips.

  3. ADD WASHER FLUID (w/ Headlight Cleaner System)

    Click here

  4. ADJUST HEADLIGHT ASSEMBLY (for LED Type Turn Signal Light)

    Tech Tips

    Perform this procedure only when replacement of the front bumper reinforcement is necessary.

    Click here

  5. ADJUST HEADLIGHT ASSEMBLY (for Bulb Type Turn Signal Light)

    Tech Tips

    Perform this procedure only when replacement of the front bumper reinforcement is necessary.

    Click here

  6. ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)

    Click here