FRONT BUMPER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here

PROCEDURE


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. B004KQ6

      Remove the 5 clips.

    2. B004KDBC01
      B006ZFL Remove in this Direction (1)
      B006WSJ Remove in this Direction (2)

      Disengage the guide and remove the cool air intake duct seal as shown in the illustration.

  2. REMOVE FRONT BUMPER ASSEMBLY


    1. B004KB6C01
      B006Y8C Protective Tape

      Apply protective tape around the front bumper assembly as shown in the illustration.

    2. B004L0RC01
      *a Protective Tape
      B006XFD Insert Screwdriver Here
      B006ZFL Remove in this Direction

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. B004IB3

      Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. B004JWD

      Remove the 8 screws.

    5. B004MT3C01
      B006XFD Place Hand Here
      B006ZFL Remove in this Direction

      Disengage the 3 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. B004HQMC02
      *A w/ Pre-collision System
      *B w/ TOYOTA Parking Assist-sensor System

      w/ Pre-collision System:


      1. Disconnect the connector.

    7. w/ TOYOTA Parking Assist-sensor System:


      1. Disconnect the connector.

    8. B004HM2

      Remove the 2 clips.

    9. Remove the 4 bolts.

    10. B004K0EC01
      B006ZFL Remove in this Direction

      Disengage the 2 claws and 2 guides to remove the front bumper assembly as shown in the illustration.

    11. w/ Fog Light:


      1. Disconnect the connector.

    12. B004L83

      w/ Headlight Cleaner System:


      1. Disconnect the headlight cleaner hose and drain the washer fluid.

        Tech Tips

        Use a container to collect the washer fluid.