HEIGHT CONTROL SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear height control sensor sub-assembly LH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear height control sensor sub-assembly LH Perform headlight ECU sub-assembly LH initialization Lighting system (EXT)

Click here

PROCEDURE


  1. REMOVE REAR WHEEL (for LH Side)

    Click here

  2. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

    Note

    If the rear height control sensor sub-assembly LH has been struck or dropped, replace it with a new one.


    1. B00705D

      Disconnect the connector.

    2. Remove the 2 bolts.

    3. Disengage the 2 guides to remove the rear height control sensor sub-assembly LH.