WINDSHIELD OUTSIDE MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL NO. 3 WINDSHIELD OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a No. 3 windshield outside moulding clip is necessary.


    1. B006YET

      Using a riveter with a nose piece, install 6 new No. 3 windshield outside moulding clips.

      Tech Tips

      If the mandrel of the No. 3 windshield outside moulding clip does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

      Note


      • Do not pry the No. 3 windshield outside moulding clip with the riveter, as this will cause damage to the riveter and mandrel.


      • B0071BPC02
        *a Riveter
        *b Incorrect
        *c Correct

        Confirm that the No. 3 windshield outside moulding clips are seated properly against the vehicle body.


      • Do not tilt the riveter when installing the No. 3 windshield outside moulding clip to the vehicle body.

      B0070KLC01
      *a Riveter
      *b Mandrel
      *c Incorrect

    2. Install the windshield glass sub-assembly.

      Click here

  2. INSTALL NO. 1 WINDSHIELD OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a No. 1 windshield outside moulding clip is necessary.


    1. Engage the 6 claws to install the 6 No. 1 windshield outside moulding clips as shown in the illustration.

      B006ZWGC01
      B006ZFL Install in this Direction - -

  3. INSTALL WINDSHIELD OUTSIDE MOULDING


    1. B0071H2

      Engage the 12 claws to install the windshield outside moulding.

  4. INSTALL FRONT FENDER TO COWL SIDE SEAL

    Click here