REAR COMBINATION LIGHT ASSEMBLY REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR COMBINATION LIGHT LENS AND BODY (for Bulb Type Back-up Light)

  2. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE (for Bulb Type Back-up Light)


    1. for Type A:


      1. B006ZSP

        Connect the connector.

      2. Engage the clamp to install the rear combination light socket and wire.

    2. for Type B:


      1. B006ZHC

        Engage the clamp to install the rear combination light socket and wire.

  3. INSTALL REAR COMBINATION LIGHT CORD (for LED Type Back-up Light)


    1. B006Z2Q

      Connect the connector.

    2. Engage the 2 clamps to install the rear combination light cord.

  4. INSTALL REAR TURN SIGNAL LIGHT BULB (for Bulb Type Back-up Light)


    1. Install the rear turn signal light bulb to the rear combination light socket and wire.

    2. B006YXGC01
      B006ZFL Install in this Direction

      Turn the rear combination light socket and wire with the rear turn signal light bulb as shown in the illustration to install them as a unit.

  5. INSTALL REAR COMBINATION LIGHT GASKET (for Bulb Type Back-up Light)


    1. B006XKS

      Install a new rear combination light gasket.

  6. INSTALL REAR COMBINATION LIGHT LED (for Bulb Type Back-up Light)


    1. B0070B4C01
      B006ZFL Install in this Direction

      Turn the rear combination light LED as shown in the illustration to temporarily install it.

    2. B0071LG

      Install the rear combination light LED with the screw.

    3. Connect the connector.