REAR COMBINATION LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE SPARE WHEEL COVER ASSEMBLY

    Click here

  2. REMOVE SPARE WHEEL COVER TRAY

    Click here

  3. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  4. REMOVE LUGGAGE COMPARTMENT DOOR STRIKER COVER

    Click here

  5. REMOVE REAR FLOOR FINISH PLATE

    Click here

  6. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER RH (for RH Side)

    Click here

  7. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER LH (for LH Side)

    Click here

  8. REMOVE REAR COMBINATION LIGHT COVER


    1. B004IELC01
      B006XFD Insert Moulding Remover Here
      B006ZFL Disengage in this Direction

      Using a moulding remover, disengage the 3 claws as shown in the illustration.

    2. B004J2SC01
      B006ZFL Remove in this Direction

      Disengage the 2 claws to remove the rear combination light cover as shown in the illustration.

  9. REMOVE REAR COMBINATION LIGHT ASSEMBLY


    1. B004K3W

      Disconnect the connector.

    2. B004HTBC01
      B006Y8C Protective Tape

      Apply protective tape around the rear combination light assembly as shown in the illustration.

    3. B004K2Y

      Remove the 2 screws.

    4. B004HTPC01
      *a Pin
      *b Guide
      B006ZFL Separate in this Direction

      Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the pin and 3 guides and separate the rear combination light assembly.

      Note

      To prevent the rear combination light assembly from falling when disengaging the pin and guides, lightly hold the rear combination light assembly.

    5. B004JBV

      Disengage the grommet to remove the rear combination light assembly.