HEADLIGHT ASSEMBLY(for LED Type Turn Signal Light) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Headlight ECU sub-assembly LH

  • Synchronize the vehicle information

  • Perform headlight ECU sub-assembly LH initialization

 Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System)

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE HEADLIGHT ASSEMBLY


    1. B00704SC01
      B006Y8C Protective Tape

      Apply protective tape around the headlight assembly as shown in the illustration.

    2. B0070Q8C01
      *a Bolt
      *b Screw

      Remove the bolt and 3 screws.

    3. B0071GPC01
      B006ZFL Separate in this Direction

      Disengage the guide to separate the headlight assembly as shown in the illustration.

    4. B006Y3ZC01
      *a Connector Lock Lever
      B006ZFL Disengage in this Direction

      Disengage the claw, pull down the connector lock lever as shown in the illustration and disconnect the connector to remove the headlight assembly.