WIPER AND WASHER SYSTEM FREEZE FRAME DATA


  1. FREEZE FRAME DATA


    1. Whenever a DTC is detected, the windshield wiper motor assembly stores the current vehicle state as Freeze Frame Data.

  2. CHECK FREEZE FRAME DATA


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Wiper / Trouble Codes.


      Body Electrical > Wiper > Trouble Codes
      Body Electrical > Wiper
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Wiper Switch HI (Line) Front wiper switch HI position signal (direct line) OFF or ON

      OFF: Front wiper switch not in HI position

      ON: Front wiper switch in HI position

      		 -
      Wiper Stop Position Windshield wiper motor assembly position Store Are/Lower Rev Pos, Wipe Area or Upper Rev Pos

      Store Are/Lower Rev Pos: Lower reverse position or lower

      Wipe Area: Between lower reverse position and upper reverse position

      Upper Rev Pos: Upper reverse position

      		 -
      Wiper Position Windshield wiper motor assembly position Store Are, Exchange Position or Wipe Area

      Store Are: Out of wiper operating range

      Exchange Position: Within wiper maintenance position

      Wipe Area: Within wiper operating range

      		 -
      Status of Motor Lock Windshield wiper motor assembly status Normal or Lock

      Normal: Operating normally

      Lock: Malfunctioning

      		 -
      Status of Temperature Protection Windshield wiper motor assembly temperature protection Normal, LO Operation, INT Operation or Stop

      Normal: Windshield wiper motor assembly temperature is below 95°C (203°F)

      LO Operation: Windshield wiper motor assembly temperature is 95°C (203°F) or more

      INT Operation: Windshield wiper motor assembly temperature is 100°C (212°F) or more

      Stop: Windshield wiper motor assembly temperature is 105°C (221°F) or more

      		 -
      Status of Overvoltage Windshield wiper motor assembly over voltage status Normal or Overvoltage

      Normal: Operating normally

      Overvoltage: Malfunctioning

      		 -
      Status of Low Voltage Windshield wiper motor assembly low voltage status Normal or Low Voltage

      Normal: Operating normally

      Low voltage: Malfunctioning

      		 -
      Motor Shaft Angle Windshield wiper motor assembly shaft angle status

      Min.: 0°

      Max.: 255°

      		 Almost the same as actual windshield wiper motor assembly shaft angle -
      Motor Temperature Windshield wiper motor assembly temperature status

      Min.: -128°C (-198.4°F)

      Max.: 127°C (260.6°F)

      		 Almost the same as actual windshield wiper motor assembly temperature -
      Motor Current Windshield wiper motor assembly current status

      Min.: 0 A

      Max.: 63 A

      		 Almost the same as actual windshield wiper motor assembly current -
      Motor Power Supply Voltage Windshield wiper motor assembly voltage status

      Min.: 0 V

      Max.: 63 V

      		 Almost the same as actual windshield wiper motor assembly voltage -
      Number of DTCs Number of trouble codes 0 to 255 Number of stored DTCs displayed -