FUEL LID OPENER SWITCH INSPECTION

PROCEDURE


  1. INSPECT FUEL LID OPENER SWITCH


    1. B004HHLC01
      *a

      Component without harness connected

      (Fuel Lid Opener Switch)

      Check the switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 - 5 Pressed (ON) Below 1 Ω
        2 - 5 Not pressed (OFF) 10 kΩ or higher

        If the result is not as specified, replace the fuel lid opener switch.

    2. Check the switch illumination.


      1. Apply battery voltage to the switch connector and check that the fuel lid opener switch illuminates.

        OK
        Battery Condition Specified Condition

        Battery positive (+) → Terminal 6

        Battery negative (-) → Terminal 1

        		 Illumination illuminates

        If the result is not as specified, replace the fuel lid opener switch.