SLIDING ROOF HOUSING(for Moon Roof) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof housing removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Sliding roof ECU (sliding roof drive gear)

  • Sliding roof glass sub-assembly

  • Sliding roof drive cable sub-assembly

  • Sliding roof drive gear sub-assembly

 Initialize Sliding Roof System

  • Auto operation function

  • Jam protection function

  • Key-off operation function

  • Key-linked function

  • Wireless transmitter-linked function

  • Sliding roof open warning function

Click here

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control)

Click here

Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B0071NY

Click here

PROCEDURE


  1. REMOVE SLIDING ROOF SIDE GARNISH LH


    1. B006XCE

      Disengage the 4 claws to remove the sliding roof side garnish LH.

  2. REMOVE SLIDING ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  3. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


    1. Move the sliding roof glass sub-assembly to the fully closed position.

    2. Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.

      B006Z5T

      Note

      To prevent the sliding roof glass sub-assembly and sliding roof drive gear sub-assembly from becoming misaligned, move the sliding roof glass sub-assembly (sliding roof drive cable sub-assembly) to the fully closed position before removing it.

  4. REMOVE SLIDING ROOF WEATHERSTRIP


    1. B0071JD

      Remove the sliding roof weatherstrip from the sliding roof panel sub-assembly.

  5. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

    Click here

  6. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  7. DISCONNECT SLIDING ROOF DRAIN HOSE

    Tech Tips

    Use the same procedure for all of the sliding roof drain hoses.


    1. B0070RU

      for Clamp Type:


      1. Disengage the claw and disconnect the sliding roof drain hose.

    2. B006ZK4

      for Clip Type:


      1. Expand the clip and disconnect the sliding roof drain hose.

  8. REMOVE SLIDING ROOF HOUSING ASSEMBLY


    1. Remove the 8 bolts, 6 nuts and sliding roof housing assembly.

      B0070FU