HOOD LOCK CONTROL CABLE ASSEMBLY INSTALLATION

PROCEDURE

1. Click here

   INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

   
   

   1. Pass the hood lock control cable assembly into the engine compartment.

   2. Engage the grommet.

   3. Engage the 4 clamps to install the hood lock control cable assembly.

   4. for LHD:

      
      

      1. Engage the clamp.

2. Click here

   INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   
   

   1. Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.

3. Click here

   CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

4. Click here

   INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

   Click here

5. Click here

   INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

   Click here

6. Click here

   INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)

   Click here

7. Click here

   INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)

   Click here

8. Click here

   INSTALL HOOD LOCK ASSEMBLY

   
   

   1. Apply MP grease to the sliding areas of the hood lock assembly.

   2. Connect the hood lock control cable assembly to the hood lock assembly.

   3. Install the hood lock assembly with the 2 bolts and hood lock bolt.

      7.5 N*m

      76 kgf*cm

      66 in.*lbf

      Tip:

      The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.

   4. Connect the connector.

9. Click here

   INSTALL COOL AIR INTAKE DUCT SEAL

   Click here

10. Click here

    INSTALL FRONT FENDER LINER LH (for LHD)

    Tip:

    Use the same procedure as for the RH side.

    Click here

11. Click here

    INSTALL FRONT FENDER LINER RH (for RHD)

    Click here

12. Click here

    INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (for LHD)

    Tip:

    Use the same procedure as for the RH side.

    Click here

13. Click here

    INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)

    Click here

14. Click here

    INSTALL FRONT WHEEL LH (for LHD)

    Click here

15. Click here

    INSTALL FRONT WHEEL RH (for RHD)

    Click here

16. Click here

    ADJUST HOOD SUB-ASSEMBLY

    Click here