HOOD LOCK CONTROL CABLE ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

   
   

   1. Pass the hood lock control cable assembly into the engine compartment.

   2. Engage the grommet.

   3. Engage the 4 clamps to install the hood lock control cable assembly.

   4. for LHD:

      
      

      1. Engage the clamp.

2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   
   

   1. Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.

3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

   Click here

5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

   Click here

6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)

   Click here

7. INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)

   Click here

8. INSTALL HOOD LOCK ASSEMBLY

   
   

   1. Apply MP grease to the sliding areas of the hood lock assembly.

   2. Connect the hood lock control cable assembly to the hood lock assembly.

   3. Install the hood lock assembly with the 2 bolts and hood lock bolt.

      Torque:

      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Tech Tips

      The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.

   4. w/ Engine Hood Courtesy Switch:

      
      

      1. Connect the connector.

9. INSTALL COOL AIR INTAKE DUCT SEAL

   Click here

10. INSTALL FRONT FENDER LINER LH (for LHD)

    Tech Tips

    Use the same procedure as for the RH side.

    Click here

11. INSTALL FRONT FENDER LINER RH (for RHD)

    Click here

12. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (for LHD)

    Tech Tips

    Use the same procedure as for the RH side.

    Click here

13. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)

    Click here

14. INSTALL FRONT WHEEL LH (for LHD)

    Click here

15. INSTALL FRONT WHEEL RH (for RHD)

    Click here

16. ADJUST HOOD SUB-ASSEMBLY

    Click here