POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

   Note

   The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.

   
   

   1. Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

      Torque:

      5.39 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

3. INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

   Click here

4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

5. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

6. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

   Click here

7. CONNECT REAR DOOR WEATHERSTRIP

   Click here

8. INSTALL REAR DOOR GLASS RUN

   Click here

9. INSTALL REAR DOOR PANEL PROTECTOR

   Click here

10. INSTALL REAR DOOR NO. 1 VENT SEAL

    Click here

11. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

12. INSTALL REAR DOOR NO. 2 SERVICE HOLE COVER

    Click here

13. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

14. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

15. INSTALL REAR ARMREST ASSEMBLY

    Click here

16. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

    Click here

17. INSTALL REAR DOOR ARMREST COVER SUB-ASSEMBLY

    Click here

18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    for 2AR-FE:

    Click here

    for A25A-FKS:

    Click here

    for 2GR-FKS:

    Click here

19. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

20. INSPECT POWER WINDOW OPERATION

    Click here