CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
Note
The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
Tech Tips
When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
INSTALL FRONT DOOR SERVICE HOLE COVER
INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
INSTALL COURTESY LIGHT ASSEMBLY
INSTALL FRONT ARMREST ASSEMBLY
INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
INSTALL FRONT DOOR ARMREST COVER SUB-ASSEMBLY
INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 2AR-FE:
for A25A-FKS:
for 2GR-FKS:
INITIALIZE POWER WINDOW CONTROL SYSTEM
INSPECT POWER WINDOW OPERATION