POWER WINDOW REGULATOR MOTOR(for Front Door) INSPECTION

PROCEDURE

1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

   
   
   1. 

      *a	Component without harness connected (Power Window Regulator Motor Assembly LH)
      *b	Clockwise
      *c	Counterclockwise
      *d	Motor gear

      Connect a positive (+) battery lead to connector terminal 2.

      Note

      Do not connect a positive (+) battery lead to any terminals other than terminal 2 to avoid damaging the pulse sensor inside the motor.

   2. Connect a negative (-) battery lead to connector terminals 1 and 7 or 10.

   3. Check that the motor gear rotates smoothly as follows:

      OK

      Measurement Condition Specified Condition Connect a positive (+) battery lead to terminal 2, connect a negative (-) battery lead to terminal 1, and keep them connected for 3 seconds or more. With terminals 2 and 1 connected, connect a negative (-) battery lead to terminal 10. Motor gear rotates clockwise Connect a positive (+) battery lead to terminal 2, connect a negative (-) battery lead to terminal 1, and keep them connected for 3 seconds or more. With terminals 2 and 1 connected, connect a negative (-) battery lead to terminal 7. Motor gear rotates counterclockwise

      
      

      • If the result is not as specified, replace the power window regulator motor assembly LH.

      CAUTION:

      Initialize the power window control system after installing the power window regulator motor and regulator assembly.

2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

   
   
   1. 

      *a	Component without harness connected (Power Window Regulator Motor Assembly RH)
      *b	Clockwise
      *c	Counterclockwise
      *d	Motor gear

      Connect a positive (+) battery lead to connector terminal 2.

      Note

      Do not connect a positive (+) battery lead to any terminals other than terminal 2 to avoid damaging the pulse sensor inside the motor.

   2. Connect a negative (-) battery lead to connector terminals 1 and 7 or 10.

   3. Check that the motor gear rotates smoothly as follows:

      OK

      Measurement Condition Specified Condition Connect the positive (+) battery lead to terminal 2, connect a negative (-) battery lead to terminal 1, and keep them connected for 3 seconds or more. With terminals 2 and 1 connected, connect a negative (-) battery lead to terminal 10. Motor gear rotates counterclockwise Connect a positive (+) battery lead to terminal 2, connect a negative (-) battery lead to terminal 1, and keep them connected for 3 seconds or more. With terminals 2 and 1 connected, connect a negative (-) battery lead to terminal 7. Motor gear rotates clockwise

      
      

      • If the result is not as specified, replace the power window regulator motor assembly RH.

      CAUTION:

      Initialize the power window control system after installing the power window regulator motor and regulator assembly.