REAR POWER WINDOW SWITCH INSPECTION

PROCEDURE


  1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for LH/RH DOOR)


    1. B004NVKC01
      *a

      Component without harness connected

      (Rear Power Window Regulator Switch Assembly (for LH/RH Door))

      Check the switch function.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        5 - 7 Auto up or up position Below 100 Ω
        4 - 7 Auto down or down position Below 100 Ω
        8 - 7 Auto up or auto down position Below 100 Ω
        5 - 7 Off 10 kΩ or higher
        4 - 7 Off 10 kΩ or higher
        8 - 7 Off 10 kΩ or higher

        If the result is not as specified, replace the rear power window regulator switch assembly (for LH/RH door).

    2. Check that the LED illuminates.


      1. Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.

        OK
        Battery Connection Specified Condition

        Battery positive (+) → 3

        Battery negative (-) → 1

        		 LED illuminates

        If the result is not as specified, replace the rear power window regulator switch assembly (for LH/RH door).