WIRELESS CHARGING SYSTEM Wireless Charger Power Source Circuit

DESCRIPTION

This is the power source circuit for the mobile wireless charger cradle assembly (front console box insert sub-assembly).

WIRING DIAGRAM

B004HVHE02
*a from Battery
*b ECU-DCC NO. 2
*c from ACC Relay
*d Mobile Wireless Charger Cradle Assembly (Front Console Box Insert Sub-assembly)

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY (FRONT CONSOLE BOX INSERT SUB-ASSEMBLY) POWER SOURCE)


    1. Disconnect the k1 mobile wireless charger cradle assembly (front console box insert sub-assembly) connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      k1-1 (PGND) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      k1-6 (B+) - Body ground Always 11 to 14 V
      k1-5 (ACC) - Body ground Ignition switch ACC 11 to 14 V
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR