SOLAR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during automatic light control sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B0071E9

Click here

PROCEDURE


  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  2. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

    Click here

  3. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

    Click here

  4. REMOVE DEFROSTER NOZZLE ASSEMBLY

    Click here

  5. REMOVE AUTOMATIC LIGHT CONTROL SENSOR


    1. B006XHG

      Disconnect the connector.

    2. Disengage the 2 claws to remove the automatic light control sensor.