CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 cooler thermistor removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Perform steering sensor zero point calibration | Lane departure alert system (w/ Steering Control) | |
| Pre-collision system | |||
| Memorize steering angle neutral point | Parking assist monitor system | ||
| Steering sensor |
|
Parking assist monitor system | Click herefor Initialization Click herefor Calibration |
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
PROCEDURE
- Click here
REMOVE BLOWER ASSEMBLY
- Click here
REMOVE AIR CONDITIONING HARNESS ASSEMBLY
- Click here
REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
- Click here
REMOVE NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for 3 Zone Type)
- Click here
REMOVE HEATER PIPE GROMMET
- Click here
REMOVE HEATER CLAMP
- Click here
REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
- Click here
REMOVE GROMMET SUB-ASSEMBLY
- Click here
REMOVE COOLER EXPANSION VALVE
- Click here
REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
- Click here
REMOVE NO. 1 COOLER THERMISTOR
-
Remove the No. 1 cooler thermistor.
-