AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) No Warm Air Comes Out

DESCRIPTION

If cool air blows from the registers regardless of the temperature setting of the air conditioning system, the following factors may be the cause.

Symptom Factor

  • No warm air comes out


    • (Blower control is normal)

  • Outlet air temperature does not increase


    • (Blower control is normal)


  • Engine coolant temperature (low)

  • Refrigerant volume (low)

  • No. 1 air conditioning radiator damper servo sub-assembly malfunction

  • Warm-up control

  • Blockage in heater radiator unit sub-assembly

  • Heater radiator unit sub-assembly malfunction

  • Flow shutting valve (water by-pass hose assembly) malfunction*


PROCEDURE


  1. CONFIRM MODEL

    Result
    Result Proceed to
    except A25A-FKS A
    for A25A-FKS B

    A
    B
  2. CHECK FOR DTC


    1. Check for DTCs.


      Powertrain > Engine > Trouble Codes
      OK
      SFI system DTCs are not output.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  3. READ VALUE USING GTS


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Data List.

    5. Read the Data List according to the display on the GTS.


      Powertrain > Engine > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Coolant Temperature Engine coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up

      This is the engine coolant temperature.

      Tech Tips


      • After warming up the engine, the engine coolant temperature will be 75 to 100°C (167 to 212°F).

      • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.

      • If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.

      • Check if the engine overheats if the value indicated is higher than 135°C (275°F).


      Powertrain > Engine > Data List
      Tester Display
      Coolant Temperature
      OK
      After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  4. PERFORM ACTIVE TEST USING GTS


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Air Conditioner / Active Test.

    5. Perform the Active Test according to the display on the GTS.


      Body Electrical > Air Conditioner > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Air Mix Servo Targ Pulse(D) No. 1 air conditioning radiator damper servo sub-assembly (driver side air mix) pulse

      Min.: 128

      Max.: 383


        for LHD:

      • Operates between 165 to 257 pulses


        for RHD:

      • Operates between 255 to 347 pulses

      Air Mix Servo Targ Pulse(P) No. 1 air conditioning radiator damper servo sub-assembly (front passenger side air mix) pulse

      Min.: 128

      Max.: 383


        for LHD:

      • Operates between 255 to 347 pulses


        for RHD:

      • Operates between 165 to 257 pulses

      Rear Air Mix Servo Targ Pulse No. 3 air conditioning radiator damper servo sub-assembly pulse

      Min.: 128

      Max.: 383


      • Operates between 165 to 257 pulses

      • *


      • *: for 3 Zone Type


      Body Electrical > Air Conditioner > Active Test
      Tester Display
      Air Mix Servo Targ Pulse(D)

      Body Electrical > Air Conditioner > Active Test
      Tester Display
      Air Mix Servo Targ Pulse(P)

      Body Electrical > Air Conditioner > Active Test
      Tester Display
      Rear Air Mix Servo Targ Pulse
      OK
      Each damper servo motor operates.
      Result
      Proceed to
      OK
      NG

    OK
    NG