FRONT SEAT INNER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative battery terminal	Perform steering sensor zero point calibration	Lane departure alert system (w/ Steering Control)	Click here
	Perform steering sensor zero point calibration	Pre-collision system	Click here
	Memorize steering angle neutral point	Parking assist monitor system	Click here
Occupant detection ECU Front passenger seat*1	Zero point calibration (Occupant classification system)	Occupant classification system Passenger airbag ON/OFF indicator Airbag system (Front passenger side) Seat belt warning system (Front passenger)	Click here

*1: w/ Occupant Classification System

Tech Tips

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

Click here
REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

Click here
REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
1. Disconnect each connector.
2. Disengage each clamp.
3. Remove the nut and front seat inner belt assembly.
4. Remove in this Direction
  
  Remove the front seat belt anchor plate as shown in the illustration.
REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
1. w/ Wire Harness:
  1. Disconnect each connector.
  2. Disengage each clamp.
2. Remove the nut and front seat inner belt assembly.
3. Remove in this Direction
  
  Remove the front seat belt anchor plate as shown in the illustration.