OCCUPANT DETECTION SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during occupant detection sensor (separate type front seat cushion pad) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • B0071E9

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

Tech Tips


  • Use the same procedure for the RHD side and LHD side.

  • The following procedure is for the LHD side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  2. REMOVE FRONT SEAT INNER BELT ASSEMBLY

    Click here

  3. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  4. REMOVE FRONT SEAT FRONT CUSHION SHIELD

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  5. REMOVE FRONT SEAT CUSHION SHIELD

    Click here

  6. REMOVE FRONT SEAT INNER CUSHION SHIELD

    Click here

  7. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  8. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  9. REMOVE OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)


    1. Using a screwdriver, disengage the 14 claws and remove the occupant detection sensor (separate type front seat cushion pad) from the separate type front seat cushion cover as shown in the illustration.

      B006Y50C02
      *a Screwdriver - -

  10. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here