SEAT HEATER CONTROL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during seat heater control sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed / Installed / Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here


  • Occupant detection ECU

  • Front passenger seat

 Zero point calibration (Occupant classification system)

  • Occupant classification system

  • Passenger airbag ON/OFF indicator

  • Airbag system (Front passenger side)

  • Seat belt warning system (Front passenger)

Click here

CAUTION:


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    for Manual Seat: Click here

    for Power Seat: Click here

  2. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY


    1. B00713JC02
      *a Protective Tape
      B006ZFL Remove in this Direction

      Disconnect the connector.

    2. Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the seat heater control sub-assembly as shown in the illustration.