FRONT SEATBACK HEATER(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seatback heater assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here


  • Occupant detection ECU

  • Front passenger seat*

 Zero point calibration (Occupant classification system)

  • Occupant classification system

  • Passenger airbag ON/OFF indicator

  • Airbag system (Front passenger side)

  • Seat belt warning system (Front passenger)

Click here

*: w/ Occupant Classification System

CAUTION:


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  3. REMOVE VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)

    Click here

  4. REMOVE RECLINING HINGE COVER

    Click here

  5. REMOVE RECLINING ADJUSTER RELEASE HANDLE

    Click here

  6. REMOVE SEAT ADJUSTER COVER CAP (w/ Vertical Adjuster)

    Click here

  7. REMOVE FRONT SEAT CUSHION SHIELD (w/o Vertical Adjuster)

    Click here

  8. REMOVE FRONT SEAT INNER CUSHION SHIELD (w/o Vertical Adjuster)

    Click here

  9. REMOVE FRONT SEAT CUSHION SHIELD (w/ Vertical Adjuster)

    Click here

  10. REMOVE FRONT SEAT INNER CUSHION SHIELD (w/ Vertical Adjuster)

    Click here

  11. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click here

  12. REMOVE FRONT SEAT HEADREST SUPPORT

    Click here

  13. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

    Click here

  14. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  15. REMOVE FRONT SEATBACK HEATER ASSEMBLY


    1. B00713H

      Remove the 24 tag pins and front seatback heater assembly from the separate type front seatback cover.