FRONT SEATBACK HEATER(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seatback heater assembly RH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative battery terminal	Perform steering sensor zero point calibration	Lane departure alert system (w/ Steering Control)	Click here
	Perform steering sensor zero point calibration	Pre-collision system	Click here
	Memorize steering angle neutral point	Parking assist monitor system	Click here
Occupant detection ECU Front passenger seat	Zero point calibration (Occupant classification system)	Occupant classification system Passenger airbag ON/OFF indicator Airbag system (Front passenger side) Seat belt warning system (Front passenger)	Click here

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here
Wear protective gloves. Sharp areas on the parts may injure your hands.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY RH

Click here
DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Click here
REMOVE VERTICAL ADJUSTING HANDLE RH

Click here
REMOVE RECLINING HINGE COVER RH

Click here
REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

Click here
REMOVE SEAT ADJUSTER COVER CAP RH

Click here
REMOVE FRONT SEAT CUSHION SHIELD RH

Click here
REMOVE FRONT SEAT INNER CUSHION SHIELD RH

Click here
REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Click here
REMOVE FRONT SEAT HEADREST SUPPORT

Click here
REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Click here
REMOVE SEPARATE TYPE FRONT SEATBACK COVER

Click here
REMOVE FRONT SEATBACK HEATER ASSEMBLY RH
1. Remove the 24 tag pins and front seatback heater assembly RH from the separate type front seatback cover.