LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Power Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during lumbar support adjuster assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here


  • Position control ECU assembly (driver seat)

  • Front seatback frame sub-assembly (driver seat)

  • Front seat adjuster assembly (driver seat)

 Initialize position control ECU Front power seat control system

Click here

CAUTION:


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  3. REMOVE FRONT SEAT FRONT CUSHION SHIELD

    Click here

  4. REMOVE FRONT SEAT CUSHION SHIELD

    Click here

  5. REMOVE FRONT SEAT INNER CUSHION SHIELD

    Click here

  6. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click here

  7. REMOVE FRONT SEAT HEADREST SUPPORT

    Click here

  8. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

    Click here

  9. REMOVE SEATBACK CLIMATE CONTROL BLOWER (w/ Climate Control Seat System)

    Click here

  10. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY


    1. w/ Climate Control Seat System:


      1. B006Z1HC01
        *a Clamp (A)
        *b Clamp (B)

        Disengage the clamp (A).

    2. Disconnect the lumbar support adjuster assembly connector.

    3. Disengage the clamp (B).

    4. B0071A0

      Disengage the 2 claws to separate the 2 front seatback edge protectors from the front seatback frame sub-assembly.

    5. B006WVSC01
      B006ZFL Remove in this Direction

      Remove the lumbar support adjuster assembly from the front seatback frame sub-assembly as shown in the illustration.

  11. REMOVE FRONT SEATBACK EDGE PROTECTOR

    Click here