LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during lumbar support adjuster assembly RH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative battery terminal	Perform steering sensor zero point calibration	Lane departure alert system (w/ Steering Control)	Click here
	Perform steering sensor zero point calibration	Pre-collision system	Click here
	Memorize steering angle neutral point	Parking assist monitor system	Click here

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here
Wear protective gloves. Sharp areas on the parts may injure your hands.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY RH

Click here
DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Click here
REMOVE VERTICAL ADJUSTING HANDLE RH

Click here
REMOVE RECLINING HINGE COVER RH

Click here
REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

Click here
REMOVE SEAT ADJUSTER COVER CAP RH

Click here
REMOVE FRONT SEAT CUSHION SHIELD RH

Click here
REMOVE FRONT SEAT INNER CUSHION SHIELD RH

Click here
REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Click here
REMOVE FRONT SEAT HEADREST SUPPORT

Click here
REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Click here
REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY RH
1. Disconnect the connector.
2. Disengage the clamp.
3. Disengage the 2 claws to remove the 2 front seatback edge protectors from the front seatback frame sub-assembly.
4. Remove in this Direction
  
  Remove the lumbar support adjuster assembly RH from the front seatback frame sub-assembly as shown in the illustration.
5. Remove the seatback felt from the lumbar support adjuster assembly RH.
REMOVE FRONT SEATBACK EDGE PROTECTOR

Click here