POWER SEAT SWITCH(for Front Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front power seat switch removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here


  • Position control ECU assembly (driver seat)

  • Front seatback frame sub-assembly (driver seat)

  • Front seat adjuster assembly (driver seat)

 Initialize position control ECU Front power seat control system

Click here

CAUTION:


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  3. REMOVE FRONT SEAT FRONT CUSHION SHIELD

    Click here

  4. REMOVE FRONT SEAT CUSHION SHIELD


    1. w/o Vertical Adjuster:

      Click here

    2. w/ Vertical Adjuster:

      Click here

  5. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

    Click here

  6. REMOVE RECLINING POWER SEAT SWITCH KNOB

    Click here

  7. REMOVE SEAT ADJUSTER SHIELD CLAMP BRACKET (w/ Vertical Adjuster)

    Click here

  8. REMOVE FRONT POWER SEAT SWITCH


    1. B006YV4

      w/o Vertical Adjuster:


      1. Remove the 3 screws and front power seat switch from the front seat cushion shield.

    2. B00717U

      w/ Vertical Adjuster:


      1. Remove the 2 screws and front power seat switch from the front seat cushion shield.