LUMBAR SWITCH(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lumbar power seat switch removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

CAUTION:


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY RH

    Click here

  2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  3. REMOVE VERTICAL ADJUSTING HANDLE RH

    Click here

  4. REMOVE RECLINING HINGE COVER RH

    Click here

  5. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

    Click here

  6. REMOVE SEAT ADJUSTER COVER CAP RH

    Click here

  7. REMOVE FRONT SEAT CUSHION SHIELD RH

    Click here

  8. REMOVE FRONT LUMBAR POWER SEAT SWITCH


    1. B00704C

      Remove the 2 screws and front lumbar power seat switch from the front seat cushion shield RH.