OCCUPANT CLASSIFICATION ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during occupant detection ECU removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of the occupant detection ECU

  • Removal/installation of the front passenger seat

 Zero point calibration (Occupant classification system)

  • Occupant classification system

  • Passenger airbag ON/OFF indicator

  • Airbag system (Front passenger side)

  • Seat belt warning system (Front passenger)

Click here

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY RH

    Click here

  2. REMOVE OCCUPANT DETECTION ECU


    1. B006XMNC01
      *a Protective Tape

      Disconnect the 2 connectors.

    2. Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the occupant detection ECU.