SIDE AIRBAG SENSOR(for Center Pillar) ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the side No. 1 airbag sensor.

B004NZ8

PROCEDURE


  1. INSPECT SIDE NO. 1 AIRBAG SENSOR (for Vehicle not Involved in Collision)


    1. Perform a diagnostic system check.

      Click here

  2. INSPECT SIDE NO. 1 AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag not Deployed)


    1. Perform a diagnostic system check.

      Click here

    2. Visually check the side No. 1 airbag sensor for defects if a center pillar of the vehicle or the area around a center pillar is damaged.

      Tech Tips

      The defects are as follows:


      • Cracks in the sensor housing

      • Dents in the sensor housing

      • Chips in the sensor housing

      • Cracks or other damage to the connector

      • Damage to the serial number

      OK
      No defects are found.

      If any defects are found, replace the side No. 1 airbag sensor with a new one.

  3. INSPECT SIDE NO. 1 AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag is Deployed)


    1. When airbags have deployed as the result of a collision, be sure to replace all side No. 1 airbag sensor in the damaged areas (anywhere in need of repair).

    2. Visually check the side No. 1 airbag sensor in undamaged areas for defects.

      Tech Tips

      The defects are as follows:


      • Cracks in the sensor housing

      • Dents in the sensor housing

      • Chips in the sensor housing

      • Cracks or other damage to the connector

      • Damage to the serial number

      OK
      No defects are found.

      If any defects are found or a side No. 1 airbag sensor has detected a major collision, replace the side No. 1 airbag sensor with a new one.