PRE-COLLISION SYSTEM, Diagnostic DTC:C1A46

DTC Code DTC Name
C1A46 Yaw Rate Sensor

DESCRIPTION

If the millimeter wave radar sensor assembly receives a yaw rate sensor malfunction signal from the yaw rate sensor (airbag sensor assembly) or yaw rate sensor zero point malfunction signal from the skid control ECU (brake actuator assembly), DTC C1A46 will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A46 Yaw Rate Sensor

  • While the vehicle is being driven at a speed of 5 km/h (4 mph) or more, the millimeter wave radar sensor assembly receives a yaw rate sensor malfunction signal from the yaw rate sensor for approximately 10 seconds.

  • While the vehicle is being driven at a speed of 5 km/h (4 mph) or more, the millimeter wave radar sensor assembly receives a yaw rate sensor zero point malfunction signal from the skid control ECU (brake actuator assembly) for approximately 10 seconds.

  • Vehicle stability control system

  • Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

Note


  • When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.

  • If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.

    Click here

  • The pre-collision system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.

    Click here

PROCEDURE


  1. CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)

    Tech Tips

    Pre-collision system DTC C1A46 may be stored due to a malfunction in the vehicle stability control system. Therefore, it is necessary to check for and troubleshoot vehicle stability control system DTCs first.


    1. Check for DTCs.


      Chassis > ABS/VSC/TRC > Trouble Codes
      Result
      Result Proceed to
      Vehicle stability control system DTCs are not output A
      Vehicle stability control system DTCs are output B

    B

    GO TO VEHICLE STABILITY CONTROL SYSTEM Click here

    A

  2. CHECK FOR DTCs (PRE-COLLISION SYSTEM)


    1. Clear the DTCs.


      Body Electrical > Pre-Collision 2 > Clear DTCs

    2. Perform the following procedure.

      Tech Tips

      If the following procedure is not performed, the previously output DTC cannot be detected.


      1. Drive the vehicle at a speed of 5 km/h (4 mph) or more for 10 seconds or more.

    3. Check for DTCs.


      Body Electrical > Pre-Collision 2 > Trouble Codes
      Result
      Result Proceed to
      DTC C1A46 is not output A
      DTC C1A46 is output B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

    REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY Click here