CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during curtain shield airbag assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    B0071NY

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

    CAUTION:

    When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.

    B006YV9C02
    B006Y8C Deployment Side

    Note

    When removing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      B006XLM
    3. B0070VMC01
      *a Airbag Connector
      *b Airbag Connector Locking Button
      *c Protective Tape
      B006ZFL Release in this Direction

      Using a screwdriver with its tip wrapped with protective tape, release the airbag connector locking button and disconnect the airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    4. Using needle nose pliers, remove the 4 pins from the 4 clips (A).

      Note

      Do not damage the pins.

      B007007C01
      *1 Pin *2 Spacer
      *a Clip (A) *b Clip (B)
      *c Spacer Location - -
      B006ZFL Remove in this Direction - -

    5. Using 2 screwdrivers, disengage the 2 claws of each clip (A), and separate the 4 clips (A) from the vehicle body as shown in the illustration.

      Tech Tips

      Separate the 4 clips (A) and curtain shield airbag assembly from the vehicle body as a unit.

    6. Disengage the 5 clips (B).

    7. While holding the curtain shield airbag assembly, remove the 4 bolts and curtain shield airbag assembly.

    8. Remove the 4 clips (A) and a spacer from the curtain shield airbag assembly.