CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

    Note

    When installing a curtain shield airbag assembly, have assistants hold it to prevent it from bending.


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      B006XLM

    3. Insert the 3 hooks, install the curtain shield airbag assembly with 4 new bolts, a new spacer, 4 new clips (A) with pins, and engage the 5 clips (B) in the order shown in the illustration.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Note

      Do not twist the curtain shield airbag assembly when installing it.

      Tech Tips

      Engage the 2 claws to install each new clip (A).

      B006ZJ8C01
      *1 Pin *2 Spacer
      *a Clip (A) *b Clip (B)
      *c Spacer Location - -
      B006ZFL Install in this Direction - -

    4. Using needle nose pliers, push the 4 pins into the 4 clips (A).

      Note


      • Do not damage the pins.

      • Make sure that the pins of the clips (A) are pushed in firmly.

    5. B006XCAC01
      *a Airbag Connector
      *b Airbag Connector Locking Button
      B006ZFL Push in this Direction

      Connect the airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    6. Push in the airbag connector locking button to install the airbag connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here