REAR SEAT SIDE AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR SEAT AIRBAG ASSEMBLY


    1. Install the rear seat airbag assembly with 2 new nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Note


      • Do not reuse the nuts.

      • Make sure that the rear side seatback frame sub-assembly is not deformed. If it is deformed, replace it with a new one.

    2. Connect the wire harness to the wire harness clamp.

    3. Engage the clamp.

  2. INSTALL REAR SIDE SEATBACK COVER WITH PAD

    Click here

  3. INSTALL REAR SEAT SHOULDER BELT GUIDE

    Click here

  4. INSTALL REAR SIDE SEATBACK ASSEMBLY

    Click here

  5. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

  6. INSTALL REAR SEAT CUSHION LOCK HOOK

    Click here

  7. INSTALL REAR SEAT CUSHION ASSEMBLY

    Click here

  8. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  10. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  11. INSPECT SRS WARNING LIGHT

    Click here