Click here

HEADUP DISPLAY REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headup display (meter mirror sub-assembly) removal/installation are shown below.

Table 1. Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here
CAUTION:
B0071E9

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

Click here

PROCEDURE


  1. Click here

    REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Tip:

    Use the same procedure as for the LHD.

    Click here

  2. Click here

    REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

    Tip:

    Use the same procedure as for LHD.

    Click here

  3. Click here

    REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

    Tip:

    Use the same procedure as for LHD.

    Click here

  4. Click here

    REMOVE DEFROSTER NOZZLE ASSEMBLY

    Tip:

    Use the same procedure as for LHD.

    Click here

  5. Click here

    REMOVE METER MIRROR SUB-ASSEMBLY


    1. B0071AY

      Remove the 3 screws and meter mirror sub-assembly.