VANITY LIGHT SWITCH INSPECTION

PROCEDURE


  1. INSPECT VISOR ASSEMBLY LH

    B004LYRC07
    *a

    Component without harness connected

    (Visor Assembly LH)
    *b Visor up
    *c Visor down
    *d Mirror Cover

    1. Inspect the vanity light switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 Visor up 10 kΩ or higher
        1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
        1 - 2 Mirror cover fully open with visor down Below 1 Ω

        If the result is not as specified, replace the visor assembly LH.

  2. INSPECT VISOR ASSEMBLY RH

    B004MCHC07
    *a

    Component without harness connected

    (Visor Assembly RH)
    *b Visor up
    *c Visor down
    *d Mirror Cover

    1. Inspect the vanity light switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 Visor up 10 kΩ or higher
        1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
        1 - 2 Mirror cover fully open with visor down Below 1 Ω

        If the result is not as specified, replace the visor assembly RH.