INSPECT ILLUMINATED ENTRY SYSTEM OPERATION
Note
Perform this inspection with the customize parameters at the initial settings.
Tech Tips
Perform this inspection with the door linked switch of the map light (roof console box sub-assembly) on.
| Control | Condition | Lights that Operate |
|---|---|---|
| Actuation Area-linked*1 | With the engine switch off and all of the doors closed and locked, enter an exterior detection area while carrying an electrical key transmitter and check that the lights that operate turn on for approximately 15 seconds and then turn off. |
|
| Door Lock/Unlock-linked | With the ignition switch off and all of the doors closed and locked, unlock any door using an unlock operation (key-linked, wireless or entry unlock operation) and check that the lights that operate turn on for 15 seconds and then turn off. |
|
| Door Open/Close-linked | With the ignition switch off and all of the doors closed, open any door and check that the lights that operate turn on. While the lights that operate are on, close all of the doors and check that the lights that operate turn off after approximately 15 seconds. |
|
| With the engine switch off and all of the doors closed, open any door and check that the light that operates turns on. While the light that operates is on, close all of the doors and check that the light that operates turns off after approximately 40 seconds. | Engine Switch Illumination*1 | |
| With the ignition switch in ON, open any door and check that the lights that operate turn on. While the lights that operate are on, close all of the doors and check that the lights that operate turn off. |
|
|
| Engine Switch-linked*1 | Turn the engine switch from on (ACC) or on (IG) to off and check that the lights that operate turn on for approximately 15 seconds and then turn off. |
|
| Turn the engine switch from on (ACC) or on (IG) to off and check that the light that operates turns on for approximately 40 seconds and then turns off. | Engine Switch Illumination | |
| Ignition Switch-linked*2 | Turn the ignition switch from ACC or ON to off and check that the lights that operate turn on for approximately 15 seconds and then turn off. |
|
| Shift Position-linked | With the ignition switch in ACC or ON, move the shift lever from P to any other position and check that the lights that operate dim. While the lights that operate are on, move the shift lever to P and check that the lights that operate return to full brightness. |
|
*1: w/ Smart Entry and Start System
*2: w/o Smart Entry and Start System
*3: w/ Footwell Light
*4: w/ Front Door Inside Handle Illumination Light
*5: w/ Rear Door Inside Handle Illumination Light
*6: w/ Instrument Panel Ambient Illumination Light
INSPECT BATTERY SAVING CONTROL OPERATION
The operations and conditions of this control are described below.
| Control | Condition | Lights that Operate |
|---|---|---|
| Basic operation | When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off. Tech Tips Battery saving control is canceled when any of the following operations is performed before the lights are turned off by battery saving control. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.
|
|
| Interior light auto cut operation | When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off. Tech Tips Battery saving control is canceled when any of the following operations is performed before the lights are turned off by battery saving control. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.
|
|
*1: w/ Smart Entry and Start System
*2: w/o Smart Entry and Start System
*3: w/ Footwell Light
*4: w/ Front Door Inside Handle Illumination Light
*5: w/ Rear Door Inside Handle Illumination Light
*6: w/ Instrument Panel Ambient Illumination Light