KEY REMINDER WARNING SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Key Unlock Warning SW Unlock warning switch signal OFF or ON

      OFF: No key in ignition key cylinder

      ON: Key in ignition key cylinder

      		 -
      FL Door Courtesy SW Front door courtesy light switch assembly (for LH) signal OFF or ON

      OFF: Front door LH closed

      ON: Front door LH open

      		 -

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter/ Active Test.

    5. Perform the Active Test according to the display on the GTS.


      Body Electrical > Combination Meter > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Buzzer Operation (800Hz, Vol L, W/ Damping)

      Combination meter buzzer


      • Frequency: 800Hz

      • Volume: Large

      • Fading tone

      		 ON -
      Buzzer Operation (800Hz, Vol L, W/O Damping)

      Combination meter buzzer


      • Frequency: 800Hz

      • Volume: Large

      • Continuous tone

      		 ON -
      Buzzer Operation (800Hz, Vol S, W/ Damping)

      Combination meter buzzer


      • Frequency: 800Hz

      • Volume: Small

      • Fading tone

      		 ON -
      Buzzer Operation (800Hz, Vol S, W/O Damping)

      Combination meter buzzer


      • Frequency: 800Hz

      • Volume: Small

      • Continuous tone

      		 ON -