WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Smart Entry and Start System) HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • If the wireless door lock control system does not operate, make sure that the wireless door lock control system is not turned off through a customize setting.

  • The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating properly. Check the power door lock control system first before troubleshooting the wireless door lock control system. Use this procedure to troubleshoot the wireless door lock control system.

  • If 2 or more door control transmitter module set sub-assemblies are registered to the system, make sure to perform troubleshooting with all of them.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. CUSTOMER PROBLEM ANALYSIS CHECK

    Tech Tips


    • In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

    • Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

    • The following 5 items are important points for problem analysis:

      What Vehicle model, system name
      When Date, time, occurrence frequency, whether the problem occurred recently or has been occurring for a long time
      Where Whether the problem occurs at a specific location
      Under what conditions? Whether the doors were locked or unlocked, whether the ignition switch was on, whether the engine has started
      How did it happen? Problem symptoms
    Result
    Proceed to
    NEXT

    NEXT

  3. PRE-CHECK


    1. Measure the battery voltage.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    2. Check the fuses and relays.

    3. Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Using the GTS, check for CAN communication system DTCs.

      Click here

      Result
      Result Proceed to
      CAN DTCs are not output A
      CAN DTCs are output B

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  5. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

    B

    GO TO STEP 7 Click here

    A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Terminals of ECU

      Click here

    2. Data List / Active Test

      Click here

    3. Operation Check

      Click here

    4. Inspection

      Result
      Proceed to
      NEXT

    NEXT

  7. REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  8. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END