ACCESSORY GATEWAY ECU INSTALLATION

PROCEDURE

1. INSTALL ACCESSORY GATEWAY ECU (NETWORK GATEWAY ECU)

   
   

   1. Engage the clamp.

   2. Connect the accessory gateway ECU (network gateway ECU) connector.

   3. Install the accessory gateway ECU (network gateway ECU) with the nut.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

2. INSTALL NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY

   Click here

3. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

4. INSTALL NO. 1 METER HOOD CLUSTER

   Click here

5. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY

   Click here

6. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

7. INSTALL NO. 2 METER HOOD CLUSTER

   Click here

8. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

9. INSTALL INSTRUMENT SIDE PANEL LH

   Click here

10. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

    Click here

12. INSTALL FRONT DOOR SCUFF PLATE LH

    Click here

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here