ULTRASONIC SENSOR(for Rear) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR CORNER ULTRASONIC SENSOR RETAINER

   Tech Tips

   
   

   • Perform this procedure only when replacement of the rear corner ultrasonic sensor retainer is necessary.

   • If a rear corner ultrasonic sensor retainer has been removed, replace it with a new one. Install the rear corner ultrasonic sensor with a new rear corner ultrasonic sensor retainer as a set to the rear bumper assembly.

   
   

   1. 

      Engage the 2 claws to install a new rear corner ultrasonic sensor retainer to the rear corner ultrasonic sensor.

   2. Clean the surface of the rear bumper assembly.

      
      

      1. Remove any remaining double-sided tape from the rear bumper assembly.

      2. Wipe off any adhesive residue with cleaner.

   3. 

      *a	19 mm (0.748 in.)

      Cover the sensor installation hole with a 19 mm (0.748 in.) circular piece of tape.

   4. 

      Primer

      Using a brush or felt, apply primer or equivalent to the rear corner ultrasonic sensor retainer installation area.

      Note

      
      

      • Use a clean brush or felt.

      • Do not touch the rear bumper assembly until the primer has dried.

   5. Confirm that the primer has completely dried by touching the rear bumper assembly. Then remove the tape.

   6. Peel off the release paper from the rear corner ultrasonic sensor retainer.

   7. 

      *a	Scribed Line
      	Press area

      Align the rear corner ultrasonic sensor retainer with rear corner ultrasonic sensor with the mark on the rear bumper assembly and install it as shown in the illustration.

      Note

      
      

      • Ensure that the sensor tip is correctly inserted into the sensor installation hole of the rear bumper assembly.

      • Ensure that the rear corner ultrasonic sensor retainer is within the scribed line.

      • The double-sided tape of a rear corner ultrasonic sensor retainer will deteriorate if it is detached. Make sure to replace the rear corner ultrasonic sensor retainer with a new one when reattachment is necessary.

      Tech Tips

      Press the area shown in the illustration with a force of 30 N (3.0 kgf) for 3 seconds to securely install the rear corner ultrasonic sensor retainer to the rear bumper assembly. Confirm there is no clearance between the rear corner ultrasonic sensor retainer and rear bumper assembly.

2. INSTALL ULTRASONIC SENSOR CLIP

   Tech Tips

   Perform this procedure only when replacement of the ultrasonic sensor clip is necessary.

   
   

   1. 

      Engage the clamp to install the ultrasonic sensor clip to the wire.

3. INSTALL REAR CORNER ULTRASONIC SENSOR

   
   

   1. When replacing only the rear corner ultrasonic sensor:

      
      

      1. 

         Install in this Direction

         Engage the 2 claws to install the rear corner ultrasonic sensor as shown in the illustration.

   2. 

      Install in this Direction

      Engage the claw as shown in the illustration.

   3. Connect the connector.

4. INSTALL REAR BUMPER ASSEMBLY

   Click here

5. PERFORM CALIBRATION

   Click here