BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:U0233

DTC Code DTC Name
U0233 Lost Communication with Blind Spot Monitor Master Module

DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH judges that there is a communication problem with the blind spot monitor sensor RH.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0233 Lost Communication with Blind Spot Monitor Master Module The blind spot monitor sensor (slave) cannot receive signals from the blind spot monitor sensor (master)

  • Blind spot monitor sensor RH

  • Blind spot monitor sensor LH

  • Wire harness or connector

CAUTION / NOTICE / HINT

Note

When checking for DTCs, make sure that the blind spot monitor system is turned on.

Tech Tips


  • Operating the engine switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.

  • Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

PROCEDURE


  1. CHECK DTC OUTPUT


    1. Turn the engine switch off.

    2. Turn the engine switch on (IG).

    3. Clear the DTCs.


      Body Electrical > Blind Spot Monitor Slave > Clear DTCs

    4. Check for DTCs.


      Body Electrical > Blind Spot Monitor Slave > Trouble Codes
      Result
      Result Proceed to
      DTC U0233 is output A
      No DTCs are output B

    B

    USE SIMULATION METHOD TO CHECK Click here

    A

  2. REPLACE BLIND SPOT MONITOR SENSOR RH

    Click here

    Result
    Proceed to
    NEXT

    NEXT

  3. CHECK DTC OUTPUT


    1. Check for DTCs.


      Body Electrical > Blind Spot Monitor Slave > Trouble Codes
      Result
      Result Proceed to
      DTC U0233 is output A
      No DTCs are output B

    A

    REPLACE BLIND SPOT MONITOR SENSOR LH Click here

    B

    END (BLIND SPOT MONITOR SENSOR RH WAS DEFECTIVE)