Click here

PARKING ASSIST MONITOR SYSTEM, Diagnostic DTC:C1625

Click here
Click here
DTC Code DTC Name
C1625 Open or Short in Steering Angle Sensor +B
Click here

DESCRIPTION

This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates a power supply problem.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1625 Open or Short in Steering Angle Sensor +B Open or short in steering sensor power source

  • Harness or connector

  • Steering sensor
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click here

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (STEERING SENSOR POWER SOURCE)


    1. Disconnect the K71 steering sensor connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      K71-9 (IG1) - K71-6 (ESS) Engine switch on (IG) 11 to 14 V
      Result
      Proceed to
      OK
      NG

    • OKClick here
    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR

  2. Click here

    CHECK HARNESS AND CONNECTOR (STEERING SENSOR POWER SOURCE)


    1. Disconnect the K71 steering sensor connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K71-6 (ESS) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      K71-4 (BAT) - K71-6 (ESS) Always 11 to 14 V
      Result
      Proceed to
      OK
      NG

    • OK

      REPLACE STEERING SENSORClick here

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR