STEREO COMPONENT AMPLIFIER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during stereo component amplifier assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ steering control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

B0071E9

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  2. REMOVE AUDIO AMPLIFIER COVER


    1. B00700N

      Remove the 3 clips and audio amplifier cover.

  3. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET


    1. B006ZQV

      Disconnect each connector.

    2. Disengage the clamp.

    3. B006YUL

      Turn back the front floor carpet assembly and front floor mat as shown in the illustration.

    4. B006XO6

      Remove the bolt.

    5. Disengage the 2 guides and remove the stereo component amplifier assembly with bracket as shown in the illustration.

      B006Z69C01
      B006ZFL Remove in this Direction (1) B006WSJ Remove in this Direction (2)

  4. REMOVE NO. 1 AMPLIFIER BRACKET


    1. B006WV9

      Remove the 2 screws and No. 1 amplifier bracket.

  5. REMOVE NO. 2 AMPLIFIER BRACKET


    1. B006ZT1

      Remove the 2 screws and No. 2 amplifier bracket.

  6. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY