RADIO RECEIVER INSTALLATION

PROCEDURE


  1. PRECAUTION (w/o Navigation System)

    Note


    • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:


      • A communication malfunction DTC may be stored.

      • The radio and display receiver assembly may not operate normally.

  2. PRECAUTION (w/ Navigation System)

    Note


    • When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:


      • A communication malfunction DTC may be stored.

      • The radio and display receiver assembly or navigation ECU may not operate normally.

    • After replacing the radio and display receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the navigation ECU.

  3. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY

  4. INSTALL NAVIGATION ECU WITH WIRE (w/ Navigation System)

  5. INSTALL NO. 2 RADIO RECEIVER BRACKET


    1. w/o Navigation System:


      1. Install the No. 2 radio receiver bracket with the 3 screws.

    2. w/ Navigation System:


      1. Install the No. 2 radio receiver bracket with the 5 screws.

  6. INSTALL NO. 1 RADIO RECEIVER BRACKET


    1. w/o Navigation System:


      1. Install the No. 1 radio receiver bracket with the 3 screws.

    2. w/ Navigation System:


      1. Install the No. 1 radio receiver bracket with the 5 screws.

  7. CONNECT NAVIGATION ECU WITH WIRE (w/ Navigation System)


    1. Connect the 2 connectors to connect the navigation ECU with wire.

  8. INSTALL MULTI-MEDIA MODULE WIRE


    1. Engage the claw.

    2. Connect the connector to install the multi-media module wire.

  9. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET


    1. Connect each connector.

    2. Engage the 2 guides to temporarily install the radio and display receiver assembly with bracket as shown in the illustration.

      B006ZKVC01
      B006ZFL Install in this Direction - -

    3. Engage the 7 clips as shown in the illustration.

      B00702XC01
      B006ZFL Install in this Direction - -

    4. Engage the 4 clips in the order shown in the illustration.

      B0070Z1C01
      B006ZFL Install in this Direction - -

    5. Install the radio and display receiver assembly with bracket with the 4 bolts.

  10. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  11. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Click here

  12. INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  13. INSTALL NO. 1 METER HOOD CLUSTER

    Click here

  14. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

    Click here