AUDIO AND VISUAL SYSTEM PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.

      System Name See Procedure
      Lane Departure Alert System (w/ Steering Control)

      Click here

      Parking Assist Monitor System
      Pre-collision System

  2. IGNITION SWITCH EXPRESSIONS


    1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression

      Ignition Switch

      (Position)

      Engine Switch

      (Condition)
      Ignition Switch off LOCK Off (Lock)
      Ignition Switch ACC ACC On (ACC)
      Ignition Switch ON ON On (IG)
      Engine Start START On (Start)

  3. PRECAUTION FOR AUDIO AND VISUAL SYSTEM

    Note


    • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:


      • A communication malfunction DTC may be stored.

      • The radio and display receiver assembly may not operate normally.